I'm looking to buy a pair of 1000cc injectors for my secondaries on my FD. Anyone know which I should buy and where to get them near the GTA? Thanks.

thewird

 

http://www.businessvision.net/edge/M...0&PageNumber=2

 

You need to send your stock 850's out to RC eng. ( http://www.rceng.com/ )to have them bored out or change your fuel rail to accept aftermarket fuel injectors.
Why not use 4x850cc injectors?

 

Well, I did consider it and even moreso when you recommended it but then did remember the fact that I most likely will get the BNR Stage 3's in the future so the 850 primary, 1000 secondary would support both configs. I'm guessing my logic isn't the best... So I should get 4x850's and then get 1200cc when I get the BNR's? If you tell me my logic was flawed, then thats good enough for me. Would I be able to get the 850's at Mazda or should I buy elsewhere? Also, any tuning sessions before the winter? Thanks.

thewird

 

Just source two used stock 850cc injectors and send them off to RC....I may have a few, I'll look tomorrow