Need help finding a 12mm banjo fitting
#1
ERTW
Thread Starter
iTrader: (2)
Join Date: Nov 2004
Location: Waterloo, Ontario
Posts: 880
Likes: 0
Received 0 Likes
on
0 Posts
Need help finding a 12mm banjo fitting
Hey guys,
I need help locating a fitting like what is shown below in order to get my FB up and running again. The original factory banjo fitting is corroded and will not hold a seal. Fuel is leaking everywhere.
I'm looking for a 12mm ID banjo fitting with a 3/8" or so barbed end. I'm thinking somewhere like Regional Hose may have this, but I wanted to confirm before heading out on a hunt.
I'm in the Waterloo area.
Thanks.
I need help locating a fitting like what is shown below in order to get my FB up and running again. The original factory banjo fitting is corroded and will not hold a seal. Fuel is leaking everywhere.
I'm looking for a 12mm ID banjo fitting with a 3/8" or so barbed end. I'm thinking somewhere like Regional Hose may have this, but I wanted to confirm before heading out on a hunt.
I'm in the Waterloo area.
Thanks.
#3
ERTW
Thread Starter
iTrader: (2)
Join Date: Nov 2004
Location: Waterloo, Ontario
Posts: 880
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, I'm going to give Regional Hose a call tomorrow first thing. Otherwise I'll ask one of the Pipefitters at work if they know where I can source one.
I figured out after the fact that I should have just installed an FD fuel filter.
That filter has the inlet/outlet more or less in the same place, except it has a barbed hose fittings and not a stupid banjo fittings. The FB is the only RX-7 that uses banjo fittings.
I figured out after the fact that I should have just installed an FD fuel filter.
That filter has the inlet/outlet more or less in the same place, except it has a barbed hose fittings and not a stupid banjo fittings. The FB is the only RX-7 that uses banjo fittings.
Thread
Thread Starter
Forum
Replies
Last Post