Redoing my brake lines. Making it a cleaner install since removal of the abs.

I need a M10-1.0mm Double banjo bolt and 10mm washers. Inverted flare.

These seem to come from the abs system that I threw away

Any ideas? Anybody have an old abs kicking around?

Ian

 

I think I may have one...I'll check later and PM you

 

interestingly enough you should be able to get the part # from the parts fische and get it from the dealership...but, this should be a last resort. i've done it for a few bolts and it's kind of rediculous the cost. like $5 for a bolt or a washer

 

Jim,

Thanks for the reply. You must have a gold mine hiding in your garage!


coldfire
They don't have the double banjo bolt. Just the single. They have fittings that goes onto the banjo bolt which I will order from them. Ya those bolts are expensive. I have a few bolts here now that I've ordered for my rear suspension pieces. I was amazed at the prices of one small nut.

 

The double banjo bolt is not a stock part on rx7s.

 

hmm, interesting. guess if it is only on the ABS system, then that is technically not an OEM part. was the ABS made by Bosch? i forget now...

 

Fastener store. Facca, Brafasco, etc. If they don't have it in stock, they can certainly get it for you. Sometimes a hydraulic shop is a better choice for banjo bolts as well.

 

Ian, I have one, It's yours for the asking. Send that Jason over to get it and tell him to bring back my flywheel socket.

 

hello to you too jim.
how goes teh car?

 

Bring the beer...lol

 

Your the best

 

what do you like?