My 13B PP WTCC SPEC Race car build thread
 

Start my build thread here

A little bit about my self

been Lived in USA around 15 years

now move back to Taiwan (asia)

RX-7 is always one of my favor car n racing is my passion


here are the story of how one Fast street 1980 GSL turn into a Full brown WTCC spec Monster

pic 1 is the car back in Street driving area

with Tri- point build GSL-SE engine TEC-2

n MAZDAcomp flywheel n clutch n lots bolt on


n you can see how 3 year can do to a car ;)

https://www.rx7club.com/attachments/...5_954460_o-jpg



https://www.rx7club.com/attachments/...12223690_o-jpg

My old build thread back in 2007

https://www.rx7club.com/1st-generati...ighter-709726/

https://www.rx7club.com/attachments/..._2692787_o-jpg


https://www.rx7club.com/attachment.p...4&d=1386222902


https://www.rx7club.com/attachments/...86603110_n-jpg

When i switch to 13B Motec EFI

https://www.rx7club.com/naturally-as...-build-986577/



https://www.rx7club.com/attachment.p...1&d=1386223919

Just down load rx7club app
With this app I can upload more often on my build thread :)

Attachment 535304

Been busy doing major update of my car


One of them is front end down force~

Looking pretty good in my opion :)

Nice! Digging all the custom parts on your build.

Finish~

Will test fit next week :)

i have always dug your car. glad to see you're continuing development with it. i guess i didn't realize the level of competition.

Nice looking car man!

Finally get time to install the front diffuser~
Can't wait for first shake down at end of nov!!

Attachment 543436

Another view with Quick release
Attachment 544202

Finish with new engine mount with drysump oil system

Attachment 547217

some video from other ST-86at last race My car pass at 5min mark

althought i did not get my best lap time at that race (due to supension setup error)

that still a very fun race after all

Some pic from the race

Attachment 548752



Attachment 548751

What have you done to the front suspension? I'm so inspired by your car. I even tell people that's what I want mine to look like when it's done. Any information you can give would help a lot. Mines for drifting but still needs a good suspension to actually be competitive.

thanks for kind word

I have Ae86 front hub, with custom control arm that is 3inch longer wider then stock one

How did you get the hub onto the 7 spindle?

i use Ae86 spindle

Does it bolt to the 7 control arm?

What do you have for a steering setup?

Here are my front suspension setup
Attachment 552065

been fighting driveshaft vib for years

finally order this bad ass shaft !!

during last race. have rear wheeling bearing failure~ time to upgrade to full floating axle.

15x10 slick is too much ask for that tiny rear wheel bearing!!!

Have not update this thread for a while, too busy on others RX-7 my FB still waiting right timing to finish my full floating axle setup with new brake!!!