staged activation
#1
staged activation
my kit: 150psi pump and the 361-500 hp rating
http://www.coolingmist.com/detailmain.aspx?pid=Cool150
i was thinking of running two nozzles in a staged set-up. an M3 nozzle to activate at 4-5 PSI and another M3 to activate at 10PSI. i am not running a progressive controller. would i just need a second boost switch to do this, and just split the wires? or would a complete secondary system be needed (pump, boost switch, ect)?
Side note if anyone can help here:
im trying to figure out wich nozzle i have. i bought the cool150 kit ($199.00) with the 150PSI pump and chose the 361-500 HP rating. is this the M5 nozzle? and also, it says on my pump that i should not run pure alchohol through the pump, or anything more than 50/50. whats the difference between meth and alchohol? because it says under feature that its all 100% methanol compatible.
http://www.coolingmist.com/detailmain.aspx?pid=Cool150
i was thinking of running two nozzles in a staged set-up. an M3 nozzle to activate at 4-5 PSI and another M3 to activate at 10PSI. i am not running a progressive controller. would i just need a second boost switch to do this, and just split the wires? or would a complete secondary system be needed (pump, boost switch, ect)?
Side note if anyone can help here:
im trying to figure out wich nozzle i have. i bought the cool150 kit ($199.00) with the 150PSI pump and chose the 361-500 HP rating. is this the M5 nozzle? and also, it says on my pump that i should not run pure alchohol through the pump, or anything more than 50/50. whats the difference between meth and alchohol? because it says under feature that its all 100% methanol compatible.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM