Power for the pump
#1
Power for the pump
I'm trying to wire in my system, Snow Performance Stage II.
The instructions say the following:
Switched power goes to the controller, then controller then runs power straight to the pump. What wire in the engine bay is best to tap for this purpose? Its the Shurflow 150lb pump.
Thanks.
The instructions say the following:
Switched power goes to the controller, then controller then runs power straight to the pump. What wire in the engine bay is best to tap for this purpose? Its the Shurflow 150lb pump.
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM