My AI build up thread
#51
mhhh
iTrader: (21)
1. Did you ever figure out a way to log 2 egt's at once then?
2. You used a pwm output correct? So this won't allow you to fine tune like FJO's 3d map will it? I am considering ditching my PFC for my 13b-re build up and going with the haltech. Being able to control the injector from the haltech sounds great but I want to be able to fine tune different points on the map like a fuel injector (like FJO) and just need to know if that is how it works.
2. You used a pwm output correct? So this won't allow you to fine tune like FJO's 3d map will it? I am considering ditching my PFC for my 13b-re build up and going with the haltech. Being able to control the injector from the haltech sounds great but I want to be able to fine tune different points on the map like a fuel injector (like FJO) and just need to know if that is how it works.
#52
Rotary Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2007
Location: st. louis
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
1. havent really put any thought into it yet. I think i should be able to log a generic voltage input. i dont remeber exactly how many inputs i have left. To be honest, its to cold in the garage to do much.
2. i use a pwm out. This allows you to fine tune exactly like FJOs setup. Imagine having an additional load v. rpm map aka a fuel map for your alchy. It works well enough for me so far. I have barely gotten to drive the car after the tune. Hopefully i will get things together soon and the weather gets nice.
2. i use a pwm out. This allows you to fine tune exactly like FJOs setup. Imagine having an additional load v. rpm map aka a fuel map for your alchy. It works well enough for me so far. I have barely gotten to drive the car after the tune. Hopefully i will get things together soon and the weather gets nice.
#54
Rotary Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2007
Location: st. louis
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
I would not be surprised if you can run 2 of the water injection solenoid drivers off of one generic pwm out. Also, it appears that you can set aux 1 and aux 2 to be the generic pwm out so you probably could run 2 solenoid drivers that way as well. I would check with haltech to make sure.
i used a relay to turn the pump on. it is always on in the current configuration. i will probably add a boost activated switch that kicsk on at 1 or 2 psi or something like that.
i used a relay to turn the pump on. it is always on in the current configuration. i will probably add a boost activated switch that kicsk on at 1 or 2 psi or something like that.
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 11:02 PM