s7 going single to4 with factory ecu?
#1
Full Member
Thread Starter
Join Date: Apr 2008
Location: roxburgh, Otago, NewZealand.
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
s7 going single to4 with factory ecu?
i have heard the ecu in these are a lot beta than the s6, 32bit or something.
i have removed emissions,full free flow 3" exhaust and twin apexi pods and the computer has adjusted and run all thous mods hocked up a AFR and its running very slightly rich all through the rev, load and boost rang.
is it possible that i can put to4 with my wastgate set at 9.5psi and keep the factory ecu and not damage my engien?
i have removed emissions,full free flow 3" exhaust and twin apexi pods and the computer has adjusted and run all thous mods hocked up a AFR and its running very slightly rich all through the rev, load and boost rang.
is it possible that i can put to4 with my wastgate set at 9.5psi and keep the factory ecu and not damage my engien?
#2
Rotary Enthusiast
Join Date: May 2005
Location: Okayama - Japan
Posts: 986
Likes: 0
Received 0 Likes
on
0 Posts
mate ask your questions on fdowners.com
And no the factory ECU can only handle exhaust and intake as max mods. Any more mods and you will need a rebuild. I personally would play it safe and get a PowerFC even with your current mods.
And no the factory ECU can only handle exhaust and intake as max mods. Any more mods and you will need a rebuild. I personally would play it safe and get a PowerFC even with your current mods.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM