I ask this question in the 3rd gen section and had a couple of answers that it may be the tune so I want to ask here.

I have a fresh rebuild with about 2500 miles on it. (all miles added by me)

Some mods are:
-Adaptronic
-Full exhaust - intake, dp, mp, no cats, HKS Carbon exhaust

Starts fine and fires right up when cold.
It also starts fine when HOT. Like stopping for gas when car is off for 5 mins.
However, when just warm it is slow to start. It alwasy starts but just takes a few seconds. For example, car has been off for an hour or and I go to start it again.

Once started it runs great in all cases.

Just looking for advice or insight on anything I can toggle or change to see if I can eliminate the issue. Or that it is not release to the ECU at all.

 

Almost certainly a cranking fuel vs water temp table issue.

 

That would be awesome if that is all it is. Here is a shot of my current table. Anyone have any input or thoughts of what adjustments I should try.

 

Well I modified my table to the values I found from another member and think I have resolved my issue. Time will tell but I think I am good.

 

Happy to hear that mate

 

Scruggyj,

Mind posting what you changed yours too? I have the same issue.

Carl

 

See attached. I changed to this.