I am having Coil igniter issues.

So I have had problems getting t1 and t2 to fire (stock ignition) so I tested the coils and plugs and they tested good.

I then got a cheap igniter, same issue then the next day i could not get any spark out of both igniters.

I tested the ecu trigger wires and got 0.01 0.01 0.50
I then tested the coil plugs and got: pin1 12v and pin2 10v
I then disconnected ecu trigger wires pins read the same.

I was of the belief that the second pin at the coil should read 0 till it fires ???

I am using the s8 v14 base map on v14. Also the car was running on the leading plugs on my old igniter till I swapped it out

 

I just used the override option with the coils, igniter and the trigger wires disconnected.

I got IGN1 10V, IGN2 2.32v, IGN3 0.84v

 

How are the grounds looking?

 

all in order.

Been in contact with Mark should be sorted soon