When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
so I’m still trying to confirm what specific connector is required for the internal 8 and 6 pin input/output slots on the Select pcb board?
think it may require the Micro JST XH 2.54mm connector, but Adaptronic never seemed to document it any where that I can find.
this is specifically for the RX8 version, but I read somewhere that the early RX7 Selects had these and then were eliminated later. The 6-pin connector is shown clearly below with the backside of the 8-pin connector over to the left side of the pic.
Select ECU: internal input/output connector slots
