Adaptronic New engine, break in base map help needed
#1
4th engine's the charm
Thread Starter
iTrader: (1)
Join Date: Nov 2005
Location: St. Marys, MD
Posts: 656
Likes: 0
Received 0 Likes
on
0 Posts
New engine, break in base map help needed
So I have a new engine rebuild, new turbo, and completely new setup including aem coils, and of course the adaptronic plug and play series 6 ecu. The tune the builder loaded for me was set up for someone else's car, and it starts the car, but idles around 11.3 AFR, and is too rich at light acceleration (read no boost) at 10.5 ish AFR. Decel is fine but cruising causes the car to buck so I'm constantly trying to either accelerate or decelerate to avoid that. I'm not looking to fine tune the car, just get it a bit more drivable so that I can break in the motor.
What at information do I need to post to get some help ? A log file from the adaptronic software, my tune file?
any and all help is appreciated!
What at information do I need to post to get some help ? A log file from the adaptronic software, my tune file?
any and all help is appreciated!
#3
4th engine's the charm
Thread Starter
iTrader: (1)
Join Date: Nov 2005
Location: St. Marys, MD
Posts: 656
Likes: 0
Received 0 Likes
on
0 Posts
Just to close out this now useless thread, the problem was solved not with adjusting the fuel map, but selecting internal MAP sensor on the ecu. It was somehow reset to external. Adaptronic newb here, sorry folks
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic Adaptronic FD 6 series with android
MSpeed
Adaptronic Engine Mgmt - AUS
4
08-13-16 04:34 AM