M2000 S4 Wiring Diagram
Thread Starter
Joined: Feb 2012
Posts: 1,142
Likes: 135
From: Duluth, MN
M2000 S4 Wiring Diagram
Hi All!
Disclaimer: I know Adaptronic is dead, but I'm helping a friend out.
I'm helping a friend wire an M2000 into an S4 Rx7 with factory coils, CAS, and ITB's. I've wired in several Haltech's, but I'm finding conflicting information on wiring in the Adaptronic. Primarily as it relates to the factory coil wiring, RPM limits, tach, and the CAS wiring. Are there any wiring diagrams for this setup floating around that I couldn't find by searching? I found the main pin out diagram, but could use some assistance.
Is there an RPM limit in wasted spark for factory coils and if so, how can this be bypassed aside from IGN1's? I assume this engine will be revved to ~9k.
Any help greatly appreciated!
Disclaimer: I know Adaptronic is dead, but I'm helping a friend out.
I'm helping a friend wire an M2000 into an S4 Rx7 with factory coils, CAS, and ITB's. I've wired in several Haltech's, but I'm finding conflicting information on wiring in the Adaptronic. Primarily as it relates to the factory coil wiring, RPM limits, tach, and the CAS wiring. Are there any wiring diagrams for this setup floating around that I couldn't find by searching? I found the main pin out diagram, but could use some assistance.
Is there an RPM limit in wasted spark for factory coils and if so, how can this be bypassed aside from IGN1's? I assume this engine will be revved to ~9k.
Any help greatly appreciated!
Junior Member
Joined: Jun 2006
Posts: 40
Likes: 0
From: Argentina
Hi! I hope you've made some progress.
If you haven't found any data, I'd suggest checking the pinout diagram of the plug-and-play ECU for the FC-S4 and transferring the connections. The CAS interprets it as a 24-tooth gear. In the EUGENE software, you'll find each pinout in the wiring section.
If you need any further documentation, I'm trying to gather it here>> https://github.com/X-ELE/Adaptronic_archive/
If you haven't found any data, I'd suggest checking the pinout diagram of the plug-and-play ECU for the FC-S4 and transferring the connections. The CAS interprets it as a 24-tooth gear. In the EUGENE software, you'll find each pinout in the wiring section.
If you need any further documentation, I'm trying to gather it here>> https://github.com/X-ELE/Adaptronic_archive/
Thread
Thread Starter
Forum
Replies
Last Post
JDM_FC
2nd Generation Specific (1986-1992)
5
Aug 30, 2006 01:04 PM