I just got my kit from irperformance with IGN-1A coils and wiring kit. I just need to know what is supposed to be changed within eugene. Im currently running an older select series 6 ecu (pre modular series). The car is a single turbo 13b FD and i have fresh BUR9EQP plugs to go with the install. Im running conservatively rich and only about 8-9psi. No plans to go higher until i finish collecting all the fuel upgrades and install the new ecu.

 

I found this thread https://www.rx7club.com/adaptronic-e...tings-1066512/
But this info was in 2014. Seems like a start but 7 years is a long time for information/programs to change.

 

So far, here's what i've found:
I need to change the trigger settings to "custom"
Change the ignition Output Pattern to "Direct Fire - 2 Rotor"
Adjust Spark Split table to basically all "10" except for startup at "5".
Keep the Dwell time (ms) at "3.000"

Im sure there's more so im hoping some of you experienced people can help out.

 

Bueller??????????????
got the car fired up but i believe the idle was off. that or i just had a vacuum leak or the new coils overall act different.
Do i need to check the timing on each coil?