Adaptronic features 440
#1
Full Member
Thread Starter
iTrader: (6)
Join Date: Dec 2011
Location: Miami, USA
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
features 440
Hello, I'm putting my new project (rx7 fd 440) in view that I acquired the 440 I want to make the most in features, practically I will send make the wiring harness and want to know what functions can be used based on sensors that can be installed, you can install all these functions at once:
- Boost Controller Sensor.
- Control Tracción.
- Launch Control.
- Speed Sensor.
- 1era and 2da Sensor.
Etc
- Boost Controller Sensor.
- Control Tracción.
- Launch Control.
- Speed Sensor.
- 1era and 2da Sensor.
Etc
#2
Full Member
Join Date: Sep 2013
Location: Philippines
Posts: 183
Likes: 0
Received 0 Likes
on
0 Posts
Hi mate,
For boost control, we recommend using a MAC valve and you need to connect this to an aux output (we normally set this to aux3 in our basemaps). The MAP sensor is used for closed loop boost control feedback.
The best setup for launch and traction control to work, is to have four wheel speed inputs connected to the ECU. Do you still have the ABS system in your car?
Sorry, I'm not sure what you meant by "1era (primera) and 2da (segunda) Sensor" ?
Thanks.
For boost control, we recommend using a MAC valve and you need to connect this to an aux output (we normally set this to aux3 in our basemaps). The MAP sensor is used for closed loop boost control feedback.
The best setup for launch and traction control to work, is to have four wheel speed inputs connected to the ECU. Do you still have the ABS system in your car?
Sorry, I'm not sure what you meant by "1era (primera) and 2da (segunda) Sensor" ?
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
befarrer
Adaptronic Engine Mgmt - AUS
3
09-22-15 09:33 AM