Adaptronic Driving 4 secondary injectors off S6 PNP
#1
Driving 4 secondary injectors off S6 PNP
I'm working on a car that has a Xcessive LIM with (4) ID 1000 secondary injectors and a brand new Rywire harness. Before I go adding two additional secondary plugs, will the Adaptronic S6 PNP have any issues driving them? I'm definitely concerned about the small gauge 12v injector feed in the Rywire harness- but it's such a low draw it should be ok. Thanks!
#3
Banned. I got OWNED!!!
Are you running 1-2-3-4 Full Sequential @ 2.0A Current?
You'll be splitting current from 3-4 into your additional two injectors, dropping said current...
My point being that if you model said injectors (4 of them) at this given current, you can correct deadtime/flow in the "secondary injector" table.
This will get you running perfectly on 6 injectors.
You'll be splitting current from 3-4 into your additional two injectors, dropping said current...
My point being that if you model said injectors (4 of them) at this given current, you can correct deadtime/flow in the "secondary injector" table.
This will get you running perfectly on 6 injectors.
Last edited by RGHTBrainDesign; 05-17-16 at 02:55 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Charlieparker
3rd Generation Specific (1993-2002)
1
04-10-16 07:59 AM