Can't adjust dwell time - Adaptronic Select
Thread Starter
Newbie
Joined: Oct 2018
Posts: 2
Likes: 0
From: Australia
Can't adjust dwell time - Adaptronic Select
Morning Fellas,
First off it's on an 180sx SR20DET on an Adaptronic Select Plug N Play (latest firmware), which I know this forum is RX-7's but got nowhere really else to turn so hoping this thread will survive.
Recently upgraded to R8 coilpacks, everything went well, deleted factory igniter, fired straight up, however when I go to adjust dwell time (3.5ms), the car pretty much stalls out or it'll swing from 500RPM to 2000RPM then stall, if I change it back to default 2.5ms, car is 100% fine.
Just wondering if anyone has encountered this before? Any tips or tricks?
Thanks,
First off it's on an 180sx SR20DET on an Adaptronic Select Plug N Play (latest firmware), which I know this forum is RX-7's but got nowhere really else to turn so hoping this thread will survive.
Recently upgraded to R8 coilpacks, everything went well, deleted factory igniter, fired straight up, however when I go to adjust dwell time (3.5ms), the car pretty much stalls out or it'll swing from 500RPM to 2000RPM then stall, if I change it back to default 2.5ms, car is 100% fine.
Just wondering if anyone has encountered this before? Any tips or tricks?
Thanks,
Thread
Thread Starter
Forum
Replies
Last Post
seanbrowning
3rd Generation Specific (1993-2002)
19
Oct 25, 2009 11:41 PM
heb09
1st Generation Specific (1979-1985)
15
Aug 29, 2005 10:57 AM
speed_monkey
2nd Generation Specific (1986-1992)
14
Jun 20, 2005 01:30 AM