RX7SpiritR

iTrader: (1)

I'm having the non-seq with simplification done on my car, I tried searching but couldn't find an answer. My question is this, I'm taking off all the smog stuff and blocking it off and I have a stock ecu for right now. Do I have to cut certain wires at all or do something with the stock ecu to make it run without throwing out a lot of codes or going into limp mode?

Mahjik

iTrader: (1)

You don't cut the wires, you just use a resistor in the female connectors. The male connectors you can leave unplugged tucked in somewhere.

littlemilla3

iTrader: (1)

1/2 watt 300 ohm just to let you know

RX7SpiritR

iTrader: (1)

thanks guys I appreciate it. I'll let you know how it goes

Snook

iTrader: (12)

non seq sucks and its a bad idea to be removing all this stuff on the stock ecu youll probably do it wrong and the thing will ****

you must also be very proud of those polished housings mentioning it twice in your small list of mods

RX7SpiritR

iTrader: (1)

#1 its going to be with the stock ecu until I break in the motor, then the PFC and tuning comes into play. #2 that would be your opinion, not a fact and thats fine I just have different opinions about it since I have driven both and feel that non-seq is better for what I want. And on a side note: I didn't even notice that, thanks for pointing it out