WTF? Runs fine with stock computer.. dies with PFC
08-04-03, 11:16 AM
#1
LS Powered
Thread Starter
iTrader: (2)
Join Date: Mar 2002
Location: Montgomery, AL
Posts: 722
Likes: 0
Received 0 Likes
on
0 Posts
WTF? Runs fine with stock computer.. dies with PFC
Ok. Here goes..
With my PFC in the car it strats up fine but then stumbles around and wont rev up right. With all these mods and the stock computer it revs fine!!! WTF?! Do i really have 850 seconds? That the only thing I can think of.. wtf?!?!?!
I am running:
Street ported motor
3' Downpipe
3' Midpipe
3.75' Catback
Greddy Pulleys
Pettit Cold Air Intake
Full Non-Seq Twins
Removed OMP, AWS, EGR, etc etc..
Apexi Power FC Standalone with Commander
Walbro 255lph Fuel Pump
850cc injectors x 4 [I think]
Josh
With my PFC in the car it strats up fine but then stumbles around and wont rev up right. With all these mods and the stock computer it revs fine!!! WTF?! Do i really have 850 seconds? That the only thing I can think of.. wtf?!?!?!
I am running:
Street ported motor
3' Downpipe
3' Midpipe
3.75' Catback
Greddy Pulleys
Pettit Cold Air Intake
Full Non-Seq Twins
Removed OMP, AWS, EGR, etc etc..
Apexi Power FC Standalone with Commander
Walbro 255lph Fuel Pump
850cc injectors x 4 [I think]
Josh
08-04-03, 12:26 PM
#2
The Power of 1.3
Join Date: Aug 2001
Location: Shrewsbury, Massachusetts
Posts: 2,837
Likes: 0
Received 0 Likes
on
0 Posts
Did you do the pin pulling or wire cutting? Thats all I can think of. See here for how-to http://westpenn.rx-7.org/ApexiPFCpinout.htm
Also, I assume you meant 850cc primaries, since the stock secondaries are 850cc.
Also, I assume you meant 850cc primaries, since the stock secondaries are 850cc.
Thread
Thread Starter
Forum
Replies
Last Post
