I removed my harness and repaired any damaged wires, the retaped it, rewrapped with loom, and retaped again! My problem is I dont remember which connectors go to which injectors?? They all use the same connector, so if anyone knows which wire colors go to which injector, that would help tremendously! thanks

frank

 

I just happened to have my 94 shop manual out to that page ...

primary front - light green with red stripe
rear - light green with black stripe
secondary front - light green with white stripe
rear - light green
other wire on all is black with yellow stripe

 

awesome! thanks for the help. I also just downloaded the FSM and will be using that as well. thanks!

 

Sorry but what problem have your car and you decide to remove your harness and fix it?
I interesting to know because, maybe and I have problem with engine harness but I am not sure.

 

Well, I just bought the car and decided to replace all the coolant and vacuum lines, and also the fuel lines inder the hood. When removing the rats nest, I found some damaged wiring and the loom was so hard from the heat and age that I decided to strip the harness and retape it and re-loom it. Now I am putting it back together and figuring out where all the connectors go and where to start and stop taping which set of wires. Its going well, but now I am figuring out where everything goes under the Intake and its getting fun! Either way, I think it was good to fix everything to ensure proper operation. Also, I would rather do it now than take it apart a 2nd time.......its a do-able job, but you dont wanna be doing it once a month!!