3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

While cranking power turns off

Old Aug 24, 2005 | 12:12 PM
  #1  
plaguepunx's Avatar
Thread Starter
Senior Member
Tenured Member 15 Years
iTrader: (8)
 
Joined: May 2004
Posts: 490
Likes: 3
From: SoCal
While cranking power turns off

I just got my rebuilt engine back in and it wont start. Well it started once then died and wont start again. When I try to crank it over sometimes all the power will turn off but if I leave the key in the on position it will turn back on in like 10 sec? any ideas?
Reply
Old Aug 24, 2005 | 12:28 PM
  #2  
DaveW's Avatar
Racecar - Formula 2000
Tenured Member: 20 Years
 
Joined: Sep 2002
Posts: 4,034
Likes: 370
From: Bath, OH
Check your battery connections for corrosion. That will sometimes cause symptoms like yours.
Reply
Old Aug 24, 2005 | 01:30 PM
  #3  
purerx7's Avatar
Registered User
iTrader: (61)
 
Joined: Apr 2004
Posts: 7,334
Likes: 8
From: Los Angeles, CA
^ i have a similar problems, for the corrosion do you just sand down the part that goes on the terminal to clean it up?
Reply
Old Aug 24, 2005 | 04:37 PM
  #4  
TwinTriangles's Avatar
What's an RX-7 ?
Tenured Member 05 Years
 
Joined: Jul 2002
Posts: 920
Likes: 0
From: MN
Yea, Check battery connections, If not that I had very similar problem that turned out to be the ignition switch. (Damn ignition switch had my car down for like 3 weeks while I was searching for the problem)
Reply
Old Aug 24, 2005 | 07:28 PM
  #5  
maxcooper's Avatar
WWFSMD
Tenured Member 15 Years
 
Joined: Jun 2001
Posts: 5,035
Likes: 4
From: SoCal
Bad battery terminal connection or drained/dead/dyning battery. The behavior you described is precisely what happens when the battery is weak (or appears weak due to a bad connection).

Check the connections. Clean them and reinstall. If they are loose, fix them. If the terminals are well connected and it still does what you described, charge the battery. If it still does it after that, get a new battery.

If there is something preventing the engine from turning easily, fix that.

-Max
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
R7rexy
3rd Generation Specific (1993-2002)
19
Sep 2, 2015 10:24 AM
PhillyFC
General Rotary Tech Support
9
Aug 21, 2015 06:36 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 05:53 AM.