Where should I start (turbo problems)?
#1
Full Member
Thread Starter
Where should I start (turbo problems)?
My first mod was an aluminum AST. My second was a boost gauge.
Sure enough, my boost pattern goes something like 10-8-5.
That means that my second turbo is loosing pressure, or not getting activated. Right?
Where do I start?
I'm assuming that its one of those notorious vacuum hose problems. Can anyone tell me which ones to check first?
Could it be anything else? Should I be looking for cracked IC piping or something?
Sure enough, my boost pattern goes something like 10-8-5.
That means that my second turbo is loosing pressure, or not getting activated. Right?
Where do I start?
I'm assuming that its one of those notorious vacuum hose problems. Can anyone tell me which ones to check first?
Could it be anything else? Should I be looking for cracked IC piping or something?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM