Well I just finished tearing apart everything external on the block since I'm replacing all my vacuum hoses with silicone. I figured I might as well just take care of everything else I can in the process. I just removed the fuel injector rails from the engine and I want to send them out to be cleaned, balanced etc. I did search and found the thread "injector removal, reconditioning, and replacement" that thread is however over 10 years old and wish to know if RC engineering is still a good place, is Ray Malloy stil alive etc?

I do plan on making a type of thread covering the whole ordeal I'm going through. Let's say it the "The few must do reliability mods for the FD" If I have the time it will cover in detail and copious amounts of pictures the FC thermos-witch install and how to remove the water pump housing, taping the thermostat housing for a aftermarket temperature gauge and sender unit. Fuel injector service, etc.

 

WitchHunter Performance - Injector Cleaning & Flow Testing Services

 

I have used RC Fuel Injection many times without any problems.

 

AUS injection in Tempe AZ does good work.

 

What I liked about WitchHunter, when I had mine done, was they supply you with a graph of the performance of the injector before servicing and then afterwards. I've only used WitchHunter so I don't know if other shops do the same, but I thought it was cool.

 

Ya that's pretty standard. They either provide a graph or flow numbers and balancing. I've used RC a couple times because they're close to me. I'm sure most any injector specialist is fine.