I finally got A new multimeter and got the correct reading on my FD coil packs . The manual states that between terminals A and B the ohms should be less than 1.0 , I got a .9 . For those eletrowizards out there is this OK for the coils to perform correctly, or are the to close to the limit? I am back tracking an electrical problem and don't want to procide until I figure this one out.

 

You might check this thread:
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/testing-ignition-coils-spark-plug-wire-corroded-408014/

 

kick ---ssss this is why you guys are the shitsky. thanks again. needed that info fast and got in an hour . thanks again

 

You could have run a search with "ignition coil test", and had it in 15 seconds.

Dave

 

Did not think of that one especially under "FD I don't know what the f--- it is stress". Which you know is always when you need the car. Thanks again.