3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

whats the deal

Thread Tools
 
Search this Thread
 
Old Feb 8, 2006 | 10:00 AM
  #1  
blackbox's Avatar
Thread Starter
Newbie
 
Joined: Feb 2006
Posts: 4
Likes: 0
From: wichita
whats the deal

i have a 94fd it runs great in till i put it in 1st or 2nd gear! What i mean is i push in on the clutch and hold it to the floor and shift into 1st and the car wants to idle down and die or almost die? It does the same thing in 2nd? But i dont let off the clutch and the wheels aren't moving, so i know the clutch is not catching. It only does this i 1st or 2nd no other gears, and when i have it in 1 or 2nd i cant rev the motor past 4 or 5,000 rpms?
Reply
Old Feb 8, 2006 | 02:17 PM
  #2  
jd to rescue's Avatar
Senior Member
Tenured Member 05 Years
iTrader: (3)
 
Joined: Apr 2003
Posts: 542
Likes: 1
From: scottsdale, az
You may have a bad shift position sensor on the tranny or a bad wiring connection.
Reply
Old Feb 8, 2006 | 03:50 PM
  #3  
jd to rescue's Avatar
Senior Member
Tenured Member 05 Years
iTrader: (3)
 
Joined: Apr 2003
Posts: 542
Likes: 1
From: scottsdale, az
^The 1-2 position switch is located at the right rear of the tranny near the odometer gear. See FSM page J-35
Reply
Old Feb 8, 2006 | 11:47 PM
  #4  
blackbox's Avatar
Thread Starter
Newbie
 
Joined: Feb 2006
Posts: 4
Likes: 0
From: wichita
someone tried to tell me that it could be the clutch switch on the clutch pedal, i have the 1-2 switch, and the neutral switch, and the clutch switch, ive tested all of them even my extra swiches and i switched the 1-2 switch, the other switches tested good but i still have the same problem the switches i have are used. I have also did a jdm swap with the engine and tranny and ecu. everything has been swaped.
Reply
Old Feb 9, 2006 | 09:42 AM
  #5  
jd to rescue's Avatar
Senior Member
Tenured Member 05 Years
iTrader: (3)
 
Joined: Apr 2003
Posts: 542
Likes: 1
From: scottsdale, az
You may need to check the tranny wiring harness to see if there is any damage or separation of the wiring to the 1-2 position switch.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Smokeyfb33
Old School and Other Rotary
10
Oct 1, 2015 12:10 PM




All times are GMT -5. The time now is 08:37 AM.