RX7Club.com - Mazda RX7 Forum

3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:
Full Detail Automotive

What is this connector for?

Thread Tools
 
Search this Thread
 
Old May 30, 2009 | 09:39 AM
Share
  #1  
RX7 Japan's Avatar
RX7 Japan
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 123
Likes: 0
From: Italy
What is this connector for?
What is this connector for? Mine isn't connected to anything...
Attached Thumbnails What is this connector for?-connector.jpg  
Reply
0
Old May 30, 2009 | 09:42 AM
Share
  #2  
IRPerformance's Avatar
IRPerformance
Sponsor
iTrader: (41)
 
Joined: Apr 2003
Posts: 11,347
Likes: 321
From: NJ
Looks like air intake temp sensor which is on the underside of the upper intake manifold, but its hard to see where the wire is going. It should be on the same lead as the tps and iac.
Reply
0
Old May 30, 2009 | 01:41 PM
Share
  #3  
badddrx7's Avatar
badddrx7
All Spooled Up
Tenured Member 15 Years
iTrader: (7)
 
Joined: Nov 2001
Posts: 2,752
Likes: 3
From: Ironton,ohio
Wire colors will pinpoint it 100%


LAter
Reply
0
Old May 30, 2009 | 01:46 PM
Share
  #4  
theorie's Avatar
theorie
AponOUT!?
Tenured Member 15 Years
iTrader: (31)
 
Joined: Nov 2002
Posts: 3,521
Likes: 13
From: Sarasota, FL
yes i also think it is the air temp sensor. i always hate having to reach under the UIM to disconnect it every time i take the UIM off...grrrr
Reply
0
Old May 31, 2009 | 12:20 PM
Share
  #5  
RX7 Japan's Avatar
RX7 Japan
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 123
Likes: 0
From: Italy
Ok. W/ a sensor disconnected, I'm supprised that I'm not getting a check engine light or something like that. I'll look under the UIM for the air sensor,
thank you,
Mark
Reply
0
Back to Subforum
3rd Generation Specific (1993-2002)
View Next Unread
twin turbo vs. big Single




Advanced Search

All times are GMT -5. The time now is 08:36 PM.