What is this?
#1
Junior Member
Thread Starter
iTrader: (7)
Join Date: Jun 2008
Location: San Diego
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
What is this?
I broke it when I was replacing my spark plug wires (putting back on the UIM). I dumped epoxy over it to try and seal it, but it doesn't seem to have worked (I didn't think it would). So in the picture you see a bunch of epoxy. I show it and the check valve it connects to. I'm not sure what it is, but my idle is now at 1100 instead of 800 where it was before. If you know (or you have one), please let me know. Thanks.
#2
Original Gangster/Rotary!
iTrader: (213)
I'm pretty confused by looking at your pictures. Did you break the nipple off the check valve, or the hose going to it? If so, you now have a vacuum leak. Do you still have your original vacuum hoses?
#3
Rotary Enthusiast
iTrader: (2)
Join Date: Sep 2006
Location: Vancouver, BC
Posts: 1,350
Likes: 0
Received 0 Likes
on
0 Posts
I broke it when I was replacing my spark plug wires (putting back on the UIM). I dumped epoxy over it to try and seal it, but it doesn't seem to have worked (I didn't think it would). So in the picture you see a bunch of epoxy. I show it and the check valve it connects to. I'm not sure what it is, but my idle is now at 1100 instead of 800 where it was before. If you know (or you have one), please let me know. Thanks.
#4
RX-7 Bad Ass
iTrader: (55)
That may be the purge solenoid. If so, I've got a good one from a low mile JDM engine.
Also, you REALLY need to dump those stock check valves .
Dale
Also, you REALLY need to dump those stock check valves .
Dale
#5
Junior Member
Thread Starter
iTrader: (7)
Join Date: Jun 2008
Location: San Diego
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/how-test-your-solenoids-actuators-other-turbo-stuff-802060/
I think it's the one all the way on the left looking from the drivers side. Is that what you have Dale, if so, how much? Also what do I replace the check valves with?