Were I can find this wire in engine bay?
Thread Starter
Senior Member
Joined: Feb 2004
Posts: 400
Likes: 0
From: Greece
Were I can find this wire in engine bay?
I am planing to upgrade the wires for coils so Can anyone help me were to find the wire who begin from ig2 and go into engine bay.
The red one in schematic below.
The red one in schematic below.
Full Member
Joined: Oct 2004
Posts: 168
Likes: 0
From: new zealand
the diagram says it all.B/R wire that goes to each coil.If you know where the
coils are then you will find it.From memory theres three small plugs that goes to the coils but theres a main connector(bigger black) that connects to the harness
its by the front rotor housing.
coils are then you will find it.From memory theres three small plugs that goes to the coils but theres a main connector(bigger black) that connects to the harness
its by the front rotor housing.
Thread Starter
Senior Member
Joined: Feb 2004
Posts: 400
Likes: 0
From: Greece
Yes I know for the big connector,
This connector is connect direct to ig2 ?or there is and another connector as I see in schematic there is one more at the begining of ig2 that connector I would like to know were is located.
From there I want to connect a new wire and give possitve to ignition and to coils.
This connector is connect direct to ig2 ?or there is and another connector as I see in schematic there is one more at the begining of ig2 that connector I would like to know were is located.
From there I want to connect a new wire and give possitve to ignition and to coils.
development
Joined: Aug 2002
Posts: 5,714
Likes: 7
From: Lafayette, LA
HAHA!, I remember making that trace 
If you don't understand that diagram, I don't recommend doing this mod! Because I don't understand what you are calling "ig2".
there are other components that are getting 12V from that line, I hope you don't plan to find that wire and snip it.
to take full advantage of this mod you should re-wire the entire Ignitor...all wires show below.
I'd use the stock B/R wire that powers the coils to trigger a relay and power the coils straight from the battery.
If you don't understand that diagram, I don't recommend doing this mod! Because I don't understand what you are calling "ig2".
there are other components that are getting 12V from that line, I hope you don't plan to find that wire and snip it.
to take full advantage of this mod you should re-wire the entire Ignitor...all wires show below.
I'd use the stock B/R wire that powers the coils to trigger a relay and power the coils straight from the battery.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
Sep 5, 2015 10:23 AM