Well after doing some work on the car I take her out, everything seems fine, pick up some pre-mix and notice my temp gauge is bottomed out and not working. I get her back and take off the intake elbow poking around where the temp probe is above the oil pressure sender, sure enough the harness clip has popped off somehow. The problem is I can't find the lead/connector that clips on there loose anywhere. I studied the wiring diagram and it looks like it is part of the emissions harness on top of the motor, which I could have easily bumped off and then ended up stuffing under the manifold inadvertantly. Is this correct because I can't find anything on the engine harness on the driver side that is not connected?

Matt