hey guys,
does anyone happen to have the hgs grounding cables for the fd? i need to know the exact lengths of each cable cause i want to make my own. if anyone has this information, i'd appreciate it. tia.

 

I just bought the HGS kit. However, there is no need to know the length of the cables. All you need to do is make cables any length you want. You are just going to enhance the existing grounding cables, not replace them. You can follow existing grounds and add to them(tough way) or just start from the neg bat terminal, pick a spot on drivers side chassis to go to, either existing ground or a new spot. Measure, make a cable and connect it. Then pick a spot on the engine/tranny to go to, from chassis, measure make cable,connect. Go to UIM, from previous spot, repeat. Then from UIM to passanger side chassis, either use a bolt on the chassis or use a new bolt in one of the empty holes. Just chain 4-5 wires across from drivers chassis/neg bat terminal to engine points to passanger side chassis. Thats all the kit states to do and all the kit is. The kit just tells you general areas to connect to and gives you some wire. Well, I have told you general areas, now just add your own wire.

After installing mine, I wish I would have had this info and made my own, tho they wouldnt be as pretty.

Oh, the lengths(which are not for anything specific) are: 15.1", 19", 27",32", 35" I believe. The last 2-3 are too long really.

Steve