uh, more clutch questions?
#1
Rotary Enthusiast
Thread Starter
Join Date: Jun 2002
Location: abingdon, maryland
Posts: 1,447
Likes: 0
Received 0 Likes
on
0 Posts
uh, more clutch questions?
bought a spec clutch. which way is the best way to mate the tranny to the clutch. I put the ring n the pressure plate and pushed on the clutch fork to click in. Here lies the problem. I m not sure if i distorted the ring. it's hard to put it in the pressure plate but once it is mated all it needs is a little pressure for it to pop out!! last time i let it be drove around and had no clutch. I was stranded. If i tried to put the ring on the throwout bearing and try to click it into the pressure plate as a unit, it just won't click in. this **** is getting old. i might order a new ring. the spec sucks... the throw out bearing rubs and gets stuck on the clutchfork assembley. i had to grind the **** out of it for it to slide on it. kvn
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM