RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)
-   -   Transmission Noise!!! (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/transmission-noise-712422/)

samad 12-12-07 11:22 AM

Transmission Noise!!!
 
OK so i have a 93 touring with a 99spec manual swap....whenever the clutch is not pressed there is this whining noise from pretty much where the gearbox is. i step on the cluth and the noise is gone and the car idles better. in 4th gear around 2-3000 rpm the noise is real bad, kinda like a blender with veggie sin it!

soo is it something serious...or shud i just replace the oil?? btw where exactly do u change or check the transmission fluid from??

sevensix 12-12-07 11:24 AM

check the factory service manual it shows u were to check from. its on the tranny, u have to get under the car.

i think it may be your throwout bearing making the whine. or input shaft

samad 12-12-07 12:23 PM

is the throwout bearing or input shaft a serious problem?

Mahjik 12-12-07 12:41 PM

Well, an input shaft problem would most likely be a tranny rebuild or a new/used tranny replacement.

Here is a similar thread: https://www.rx7club.com/3rd-generation-specific-1993-2002-16/trans-emitting-strange-noise-316274/

You might read through it as it has some ideas on areas you can check.

7_rocket 12-12-07 12:43 PM

My input shaft went south, so I had to replace my tranny. Got a low mileage tranny and no problem. Its a pain.....

dgeesaman 12-12-07 04:50 PM


Originally Posted by samad (Post 7615964)
OK so i have a 93 touring with a 99spec manual swap....whenever the clutch is not pressed there is this whining noise from pretty much where the gearbox is. i step on the cluth and the noise is gone and the car idles better. in 4th gear around 2-3000 rpm the noise is real bad, kinda like a blender with veggie sin it!

soo is it something serious...or shud i just replace the oil?? btw where exactly do u change or check the transmission fluid from??

I'm thinking your clutch is dragging or you have a really bad input shaft bearing.

Find a good transmission shop and have them take a look - fortunately the tranny is not at all specific to rotary technology.

T.MagnumPornStarExtraordinaire 12-12-07 09:43 PM

Did this happen suddenly?
or
Has it been gradually?
Throwout bearing could be dry....

sevensix 12-12-07 09:51 PM


Originally Posted by 7_rocket (Post 7616279)
My input shaft went south, so I had to replace my tranny. Got a low mileage tranny and no problem. Its a pain.....

glad u replaced your pilot bearing at the same time

sereneseven 12-12-07 10:00 PM

Input shaft bearing

7_rocket 12-12-07 10:25 PM


Originally Posted by sevensix (Post 7618772)
glad u replaced your pilot bearing at the same time

Thanks.. :icon_tup:


All times are GMT -5. The time now is 08:51 AM.


© 2024 MH Sub I, LLC dba Internet Brands