tranny to engine
 

im trying to mate my tranny (manual) to my engine, cluth seems like it was aligned properly, i can get the tranny main gear to line up with the engine's end and i was able to push the tranny to the engine but theres something catching .. the tranny is maybe 1/2 to 3/4 of an inch from connecting to the engine fully, any insight will be most welcomed and appreciated

Different opinions but here you go:

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/transmission-wont-go-777338/

that was fast, thanks mahjik

do i have to do anything to the release collar when re-installing the tranny?

^i know i have to do this when taking the tranny off, but do i have to have the release collar in any particular position to install the tranny?

nevermind that video is useful for reinstall too, but i guess my problem is something is catching

If you have the transmission ½ inch away from the engine I would think it is the dowel's that are not setting, if everything feels right just put a bolt in the top and bottom of the bell housing and pull the tran’s into the engine by tightening the bolts slowly.

^ same thing I had to do.

it worked thanks :)