For those who have pulled their engine and sent it out for a rebuild
#1
Rotary Enthusiast
Thread Starter
Join Date: Jul 2001
Location: Nashville, TN
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
For those who have pulled their engine and sent it out for a rebuild
After pulling the engine out, what do I remove before I send it out? What do I leave on? If anyone has some pics of what it should look like that would help immensely as well.
Thanks in advance
Thanks in advance
#2
I have gone through this. If I were you I would leave off the downpipe, and all the belt drive accessories.
I would be sure to leave on the turbo's, drive pulleys, flywheel. Mainly because these things are difficult to remove with out the correct tools and the person that reassembles the motor knows the correct procedure to attach these components to the engine.
Just my 0.02 cents good luck!
matt
I would be sure to leave on the turbo's, drive pulleys, flywheel. Mainly because these things are difficult to remove with out the correct tools and the person that reassembles the motor knows the correct procedure to attach these components to the engine.
Just my 0.02 cents good luck!
matt
#3
Rotary Enthusiast
Thread Starter
Join Date: Jul 2001
Location: Nashville, TN
Posts: 1,087
Likes: 0
Received 0 Likes
on
0 Posts
oh I'm not asking about actually pulling it...I think I can do it (but thanks though). I'm looking for advice on what to do once it's pulled.
#5
Full Member
Join Date: May 2002
Location: south boston,Va
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
How much is the rebuild? Im sure i can pull it out, and pull all the accesories off, im just curiuos what a rebuild would cost? If the time ever arives where i need to rebuild, i may give it a try myself.
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM
maikelc
3rd Generation Specific (1993-2002)
8
08-24-15 11:04 AM