For those that have done the poor man NON SEQ mod...turbo control door?!?!?!
#1
Senior Member
Thread Starter
Join Date: Jul 2001
Location: Columbus, Ohio
Posts: 596
Likes: 0
Received 0 Likes
on
0 Posts
For those that have done the poor man NON SEQ mod...turbo control door?!?!?!
Okay...I got the line off of the TCA and plugged and I went on to wire the door open, but how in god's name do you hold it open and wire it at the same time? I can't figure it out, it's just too hard to open with one hand....
#3
Senior Member
Thread Starter
Join Date: Jul 2001
Location: Columbus, Ohio
Posts: 596
Likes: 0
Received 0 Likes
on
0 Posts
Ohhhh..remove it completely? Wow,, yeah that might halp, but what do I do with the small vacuum hose that goes into the side of the TCA, just plug it as well?
Right now I have just taken off all the stupid heat plates and the main hose going into the center of the TCA.
What is needed to remove the TCA? Like maybe 3-4 10mm bolts?
Right now I have just taken off all the stupid heat plates and the main hose going into the center of the TCA.
What is needed to remove the TCA? Like maybe 3-4 10mm bolts?
#4
The Dude Abides
Join Date: Mar 2001
Location: san jose, ca
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts
I think it's 2 10mm bolts. They're above and below the actuator rod. And then there's a c-clip on the rod that needs to be taken off. Then plug the 2 hoses that went to the TCA and wire the door open.
Last edited by neevosh; 05-20-02 at 09:38 PM.
Thread
Thread Starter
Forum
Replies
Last Post