I own a right had drive fd3s. I have found some one who is selling a barrel bent stainless steel downpipe and mid section. I know the mid section will fit in the advert is say that the down pipe will not fit. I have been under my fd this mornig and I can see why. the steering shaft that goes down to the rack runs close to the downpipe. Dose any one know of a way that I can make this down pipe fit?

 

It can be made to fit with a large hammer . Seriously, don't buy it. Get the right one, or you will regret it later

 

Just buy a used HKS or mindtrain downpipe off of the forum or ebay for cheap, you will have to be patient but they do pop up. It's too bad you didn't need one sooner, I sold a spare I had laying around a few months ago for 50 bucks.