Hey guys,

I'm in a bit of a jam. I redid my wiring harness (single turbo) as well as had to pull out my dash to swap the carpet to black.

When I put it all together my temperature gauge no longer reads anything on the dash, but the PFC shows the temperature just fine.

Does anyone know what I might've missed? I've gone over the dash connects and wiring harness twice and can't spot anything.

Do they both read the same sensor? I'd assume so but want to check that I can rule out the wiring harness

 

No, the temp gauge has it's own sensor in the rear iron with only one wire to it, below the oil filter if I remember correct. PFC reads from one of the sensors behind the filler neck. I had a problem with my gauge as well, was a poor connection at the sensor. Might wanna check that.