Hey guys,

I just got an Innovate LC-1 WB02 with XD gauge I'm installing. I ran the wiring for the sensor from the engine bay into the cabin on the passenger side thinking that my datalogit will be over there and most of the wires from the WBO2 need to go to that. However, I got over there and I realized the only easy-access 12V switched source I know of is in the fuse box on the driver side.

Is there a 12V switched source with easy access on the passenger side of the cabin? If not I'll just run a wire over the driver side fuse box, but I'd prefer to keep things neat and clean if I can.

- Andy

 

Radio turn on? That's what I used for boost control and wide band. I should probably have tapped the fuse box for it like I did the gauges, but I didn't want wires corsing all over the place under the dash, and I'm still strongly debating not running a radio.

 

The switched +12V on the radio harness is on the 10-wire harness. It's blue with a black stripe and in the corner of the connector plug. You can also get ground there, it's the thick black spade connector.