I have a 93 us shell that used to be auto converted to standard.

jdm motor car runs rewired everything except for x-07 different size clips and i dont want to color match just in case.

My problem is my instrament cluster doesnt light up. Also temp guage, tach doesnt come on.

Any help would be greatly appreciated like i said ive been working on this for over a month thanks!

 

It's good that you didn't connect wires based on colors, that would cause problems. Search for auto to manual conversion, there are a few people who have done it before and documented how the wiring needs to be changed.

I'm not intimately familiar with the connectors used with the auto harness, but if the old plug and new plug use the same pins the cleanest solution would be to de-pin each wire from both plugs and re-pin the new connector. This would avoid soldering or splicing. There is a very good de-pin and re-pin how-to in the 3rd Gen Section of another rotary car forum online.