I am just putting my engine harness back on and im have two problems, one i dont know where a plug goes, it's a plastic insulated female side of a spade connector type plug. I cannot remember where it goes if my life depended on it, sucks because I usually have a mental picture of every plug. Second, the little sensor below the oil filter, has a little male spade connector coming off it, well that broke as i was take the plug off (btw the other plug that i dont know where it goes has the same exact end as this one, but with a black wire and orange dots). Well what sensor is that? Oil temp?

I already have the ground from the UIM to the firewall connected and the ground bolted to the block under the UIM. Are they the only two grounds or is the plug that's unconnected the missing ground? Please help, eeeek.

 

water thermosensor=y/w == the small broken one= to the gauge yellow/white,,,,,oil pressure=gy/r,,,gray/red,,,,,,,,connector between emission[em] and engine [e] is a black wire on one connector [em] and brown/white for the other [e]

 

The water thermosensor isn't broke, that's the green plug on the coolant neck isn't it?

And I'm not quite sure what you mean from " from emission to engine"

 

Help me...

 

Is it the 2nd plug that comes off of the Thermostat housing? And isnt there a ground from the Solenoid plugs to the block via the bolts that hold the Fuel hardlines/rats nest down?

 

No i have that plug, plugged in, ill try and get a picture of the one im talking about. It is the same exact plug as the one that connected to a 12mm or 14mm sensor with a built in nut right below the oil filter. I have the ground that has a circle terminal on it bolted down already. I was just wondering if there were more then the two grounds that i currently see. ie.. The one from the UIM to the firewall and the -----=O wire with a circle connector that gets bolted down under the UIM to the block.