Hey guys i just put my car back to gether with a new engine and i cant get it to start, but if i get it a shot of starting fluid it will fire right up and run just fine. When i went to drive it just falls face first if i give it too much gas. I just have to barly hit the gas to get it going. Will idle just fine at 1500 rpms and i can rev it all day long. its a halfbridge ported with a power fc just pluged in. Does it need adjusted or does it sound like my injectors are not working properly. Any help would be greatly appreciated. Thanks

 

Occasionally a fresh motor will be stubborn until a few heat cycles pass and it builds good compression.

What injectors? What does the PFC say? If you don't have the PFC set for the correct injectors your **** will act all crazy.

 

Well I have 850 and 1660 but the pfc will only let me set them to 1500 max. Its also telling me that injectors or working at like 25 % when i try to drive it any more and it stumbles. I herd to let it run a few times to get compression but its been through 5 or 6 heat cycles, should i try more to get it to start?

 

you are in ohio have you contacted the guys at rx7store? ask for xavier

 

Ya he said he has no idea why it will not start on its own its going there in a few days to have it looked at. I was gonna try to figure it out on my own to save some money but i have not a clue as to what im doing with the pfc.