Speed limiter at 180km/h!?!?!?
 

I just done a WOT through 4th gear and noticed my car just cut out at 180km/h... my FD is completely stock besides an exhaust... do FD's have limiters? Or what? I don't want a speed limiter hehe.

Dennis,

JDM market cars do....search on how to disable it.

Any ideas of the wording of the search... haven't found any JMD FD threads... only FC's...

Dennis,

Search for speed and limiter under the 3rd gen or regional forums:

https://www.rx7club.com/showthread.p...=speed+limiter

Cut this (red/green):

http://i17.photobucket.com/albums/b8...e/fartsprr.jpg

Just remember to re-connect it if installing a Power FC, or the digital speedo wont work.

then make sure you dont cut it too close to the harness itself
or itll be a bitch to get at later:)

Exactly! :icon_tup:

don't cut anything - buy a PFC instead ;)

JDM = 180km/h limiter on ALL cars (with the exception of kei cars - which cut out, iirc, around 140)

I got to go for a ride in an imported kei car (nissan sunny? or something) and it definatly didn't need that limiter at 140, it felt like it would hardly do 130 flat out.

Where abouts is this located? I had a look at the wiring harness at the feet on the driver side, but couldn't find this... thank you.

give it another look its there, rotate the green wires to find the red stripe.

Its not on the drivers side, it on the left side. You have to remove a plastic cover to get to it. Very easy.

i stopped reading after the question mark so i thought he couldn't find the actual wire from the harness, sorry about that.

I second the PFC

There are several yellow boxes connected to the metal box. Which one is the red and green wire located on? I can't seem to take any of them off... do they take a lot of force?

Dennis,

I have taken out the yollow box located at the bottom of the metal box and was unable to find a red/green wire to cut.

Bump!

Maybe the colour of the wire could be different? I took out the yellow box at the bottom of the metal box as mentioned, I pulled it out and turned it to the side and no red/green wire. What if the wire is a different colour? Would it work if someone told me which spot the wire was in, so I could cut that wire? Or is that to risky? Need help asap... only have a short time to disconnect it.

Thanks guys.

Sorry. my bad. The wire was hidding on me :P i will test it tonight and let you know. Thanks guys.

how did it work out?? i´m about to do the same shit but there i´m a little too big to crawl around in the car and i´m not even big :)

i tried to cut the red/green wire but it was the wrong wire, when it hit the gas the car just died so i fixed it again. any other tips?

dannenhakan, it worked out fine! Try and cut the right wire this time :)

nice! but then there is this problem, which is the right wire?? :dunno:

The wire is green with a red stripe, not red/green.

JT

sorry, my bad. but thats the wire i cut. and this wire was not in the middle of the connector either. anyone has a picture that shows all wires? just like on Zebb´s picture the numbers on the ECU is the same but not the wiring