Anyone have any pictures of a complete non-seq engine bay, like close ups, and layouts? Most of the Pictures on the Sticky have grown old and can no longer be viewed.

Just verifying - The solenoid that is kept for the FPR is the Orange one correct?

Do most of you Remove the Flap in the manifold and replace the hole with an Iron plug and weld? Or do you weld the flap open?

Anyone have a picture of their wastegate ported for the Non-Seq Setup?

I currently have everything removed and just want to make sure I don't do something incorrectly.

If you could post you answers and pictures here that would be greatly appreciated. Or you can email them to Rx7oneluv@yahoo.com. A PM will work too I guess, but I would think other would want to see answers too.

Thanks everyone

 

there is a whole write up on nopistons in the 3rd gen sec

 

The first time we did it off my friends FD, we didn't have access to the computer so we had to do it with directions from my friend in ft. lauderdale, he told us over the phone how to do it, it took us about 8 hours.

 

All solenoids have the same operstion...just set up different. You don't need the FPR solenoid, you can connect the line on the FPR to the LIM, there is a nipple pointing towards the FPR.

Flap? Double throttle? remove and either plug or make a block off plate and bolt that on. Some stores sell block off plates.

There twins have to be separated to port the WG.

 

sorry ment the flap in the exhaust manifold not the intake double throttle.

 

The one operated by the TCA? Just weld the arm in the "open" position.