I'm going in for dyno tuning and need some basic yet knowledgable help. I have a power FC, datalogit combo and needed some info on how to tune. For example, if the guy says I'm lean what adjustments do I make? If rich what adjustment there? I have a downloaded configuration that matches my modifications (greddy 3 row front mount, non-seq twins, full 3 inch downpipe back through a mid pipe to an Apex GT spec catback, stock injectors, all block off plates, double throttle removed, manual boost controller set to 10 Psi, air pump removed, greddy elbow and blow off valve, direct fuel pump jumper) in my Power FC.

Just wanted some tuning help to get me started. I am still very new at this yet learn very easily and quickly.

Should I initialize the power FC first and then tune from there? The power FC was purchased used and already configured (was running rich when installed) before I imported the new configuration.

It may be much to write a reply so anyone who is capable of helping can call (631)838-8215 for verbal direct help. I've never seen anyone post a number but that tells how important I consider this help to be.

I've tuned a HKS SUper AFR before I don't know if it's anything like that (pulling fuel and adding fuel at different RPM points).

Thanks for any help in advance. Simple direction in the right direction would be fine as well like forwarding me a number for me to call for this type of help.


Timothy

 

If you've never tuned before, you do NOT want to be starting tuning under boost!

Read Brian Davies and Chuck's tuning guides to start:

http://www.zeroglabs.com/rx7/singleturbotuning.htm

I'm closing this thread as you have one in the PFC forum....