Secondary Turbo to YPipe stud ...
#1
Secondary Turbo to YPipe stud ...
...broke!
jeez..it didnt even require a great deal of torque to do it...
soaked it in PB blaster...stud extractor tool from Sears is only good for studs greater than .25 in
...last resort was vice grips ...no luck ..just stripped it ..
anyone have any ideas ?
jeez..it didnt even require a great deal of torque to do it...
soaked it in PB blaster...stud extractor tool from Sears is only good for studs greater than .25 in
...last resort was vice grips ...no luck ..just stripped it ..
anyone have any ideas ?
#3
decided to try once again with the vice grip prior to torching it...
it sheared off once again but noticed a movement upon shear..marked it before with nail polish so i could see any progress much easier...
gripped yet again of what was left of the stud and sure enough...there was movement...
it sheared off once again but noticed a movement upon shear..marked it before with nail polish so i could see any progress much easier...
gripped yet again of what was left of the stud and sure enough...there was movement...
Thread
Thread Starter
Forum
Replies
Last Post