Since I've replaced all of the other fuel lines in the engine bay I'd like to finish the job. I have the KG parts fuel rail which uses a 3/8in NPT thread, and the stock primary rail which I will tap to 1/4in NPT. Now all I have to figure out is what angle fittings I need to use. I was thinking two 90 degree fittings, or one 120 degree fitting and one 90....anyone care to shed some light on this? I would be able to test my idea if I had my LIM and fuel rail, but it's over at my friends shop getting a little shiny.

Thanks,
Dan

 

just run one 90 from the 2nd fuel rail and a straight adaptor to raill

the -6 ss line will just flex to fitting on primary rail fitting

looks better in my opinion

or just run 1 90 and 1 120 like u said

mike