Scrapping noise when clutch engaged??
#1
Aint no broke nigga
Thread Starter
Join Date: May 2003
Location: Seymour, TN
Posts: 776
Likes: 0
Received 0 Likes
on
0 Posts
Scrapping noise when clutch engaged??
When i engage the clutch I hear a clunking and scrapping noise. I figured it was either the pilot or throwout bearing. Will the bearing just wear out and the problem go away? If not, if anyones got a good deal on a clutch i'd like it...
#2
I luv my carbon footprint
Join Date: Mar 2002
Location: Indianapolis
Posts: 452
Likes: 0
Received 0 Likes
on
0 Posts
It's probably the pilot bearing and the noise will only get worse over time as the bearing wears out further. If you still hear the noise when the clutch is completely pushed to the floor it could be the throwout bearing.
Last edited by mgoddard1; 03-27-05 at 03:56 PM.
#4
Dont make me Laugh
iTrader: (8)
Join Date: Feb 2002
Location: All Hope is Lost
Posts: 1,238
Likes: 0
Received 0 Likes
on
0 Posts
Sounds like the pilot bearing. I would get it fixed sooner or later. It will eventually get hard to get into gear and then will get stuck into gear. Save some money and get a new clutch
#5
Aint no broke nigga
Thread Starter
Join Date: May 2003
Location: Seymour, TN
Posts: 776
Likes: 0
Received 0 Likes
on
0 Posts
Well I brung the car home after it started happening and let it sit and then i went out and it was still doin it and after a couple of miles it stopped completely and hasnt made the noise since. Should I still get a new clutch or has it just wore off?
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM
83revival
New Member RX-7 Technical
4
09-03-15 10:42 PM