could you tell me what you think and what connectors come with it, im thinking about purchasing one but i would like to keep the sequential setup since my engine is still stock but with several mods. i would like to go nonsequential in the far future after i rebuild my other engine.

 

They are not available for stock sequential twins. Other than that they are very nice harness, I'm in my second one.

 

Nice workmanship but it is a bit of an oddball harness. It is pinned for stock ECU/power FC but is missing several important plugs. Fortunately Dave and Ryan are helpful guys. Make sure to have them add provisions for the ISC and fuel temp sensor. They can also add a resistor pack if necessary. The lengths on the harness are also longer than stock which is a little awkward, but the loom is flexible enough that it isn't a big issue.

 

Why the fuel temp sensor, dont most setups with aftermarket rails and injectors run without it anyway? The no ISC is a bit of a strange thing to leave out, I had heard before the Rywire harness did not inculde it and was surprised at that.