RPM signal wire for Racepak G2X
Thread Starter
Rotary Enthusiast
Joined: Mar 2001
Posts: 761
Likes: 16
From: Walnut, CA
RPM signal wire for Racepak G2X
Hi guys,
We are trying to wire up the Racepak G2X datalogger system to get the RPM signal, car is a 93 RX7, ECU is POWERFC.
RACEPAK G2X has a RPM input wire, and it specifies the following signal
Engine RPM (tach input tips)
1. Signal requirement: 50% duty cycle, 5-18 volt square wave signal.
Is this signal available from the car?
We are trying to wire up the Racepak G2X datalogger system to get the RPM signal, car is a 93 RX7, ECU is POWERFC.
RACEPAK G2X has a RPM input wire, and it specifies the following signal
Engine RPM (tach input tips)
1. Signal requirement: 50% duty cycle, 5-18 volt square wave signal.
Is this signal available from the car?
Thread
Thread Starter
Forum
Replies
Last Post