Rotaryextreme headlight kit. HELP!!!
#1
Senior Member
Thread Starter
Join Date: Apr 2003
Location: fort worth, TX
Posts: 476
Likes: 0
Received 0 Likes
on
0 Posts
Rotaryextreme headlight kit. HELP!!!
Did you guys cut the springs for the highbeam lights alot to get the plug connector on the other side of the bracket? Also my lowbeam light hits the cover when i test fit it. I tried searching this but nothing came up.
#4
Rotary Enthusiast
Join Date: Jul 2004
Location: SoCal
Posts: 1,241
Likes: 0
Received 0 Likes
on
0 Posts
#5
Senior Member
Thread Starter
Join Date: Apr 2003
Location: fort worth, TX
Posts: 476
Likes: 0
Received 0 Likes
on
0 Posts
I printed out the install info. But it does not say about cutting the springs to get the light to sit far enough back for the plug. I just dont want to cut them and screw myself if you are not supposed to.
#6
No it's not Turbo'd
I didn't cut mine, but they definitely had to compress a lot, I tell you getting them adjusted and aligned, is the biggest PITA with that kit other than the cutting of the frame....
On the up side, the final "satisfaction" factor on the kit is amazing... lighting is so much better, and the whole kit brings the car up to date, as far as high end lighting goes... 3 mo. after you installed the kit you won't even remeber the tough parts
Took your post to get me to remember !
On the up side, the final "satisfaction" factor on the kit is amazing... lighting is so much better, and the whole kit brings the car up to date, as far as high end lighting goes... 3 mo. after you installed the kit you won't even remeber the tough parts
Took your post to get me to remember !
Thread
Thread Starter
Forum
Replies
Last Post
renjiv2
3rd Generation Specific (1993-2002)
57
01-25-24 03:34 AM
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM